Cisco ONS 15454 DWDM, Installation And Operation Manual

Page: 363 / 1218

5-25
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G302 Provision the TXP_MR_10G and TXP_MR_10E Client Port Alarm and TCA Thresholds
Step 8 Return to your originating procedure (NTP).
DLP-G302 Provision the TXP_MR_10G and TXP_MR_10E Client Port Alarm and
TCA Thresholds
Step 1
In node view, double-click the TXP_MR_10G or TXP_MR_10E card where you want to change the
client port alarm and TCA settings.
Step 2
Click the Provisioning > Optics Thresholds tabs. The TCA thresholds are shown by default.
Step 3
Referring to Table 5-10 , provision the Port 1 (Client) TCA thresholds for RX Power High, RX Power
Low, TX Power High, and TX Power Low based on the client interface at the other end. For additional
information about client SFP and XFP interfaces, also known as PPMs, refer to
Appendix B, “Hardware
Specifications.”
Note
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click
Refresh .
Note
Do not modify the Laser Bias parameters.
Step 4
Click Apply .
Table 5-9 TXP_MR_10G and TXP_MR_10E Trunk Port Alarm Thresholds
Card
Alarm RX
Power Low Alarm RX
Power High Alarm TX
Power Low Alarm TX
Power High
TXP_MR_10G –24 dBm –8 dBm 2 dBm 4 dBm
TXP_MR_10E –20 dBm –8 dBm 3 dBm 7 dBm
Purpose This task provisions the client port alarm and TCA thresholds for the
TXP_MR_10G and TXP_MR_10E cards.
Tools/Equipment None
Prerequisite Procedures DLP-G278 Provision the Optical Line Rate, page 5-6
DLP-G46 Log into CTC, page 2-25
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Provisioning or higher