1-36
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
78-17235-01
Chapter 1 Error Messages
EID-6006
Could not assign timing references:
- NE reference can only be used if timing mode is LINE.
- A BITS reference can only be used if timing mode is not
LINE.
- A line reference can only be used if timing mode is not
EXTERNAL.
Refer to the error message text.
EID-6008
SF BER and SD BER are not provisionable on the protect line
of a protection group.
Refer to the error message text.
WID-6009
If Autoadjust GFP Buffers is disabled, GFP Buffers Available
must be set to an appropriate value based on the distance
between the circuit end points.
Refer to the warning message text.
WID-6010
If Auto Detection of credits is disabled, Credits Available must
be set to a value less than or equal to the number of receive
credits on the connected FC end point.
Refer to the warning message text.
WID-6011
Idle filtering should be turned off only when required to operate
with non-Cisco Fibre Channel/FICON-over-SONET
equipment.
Refer to the warning message text.
EID-6012
Could not change the retiming configuration. There are circuits
on this port.
You cannot change the timing configuration
on this port unless the circuits on this port
are deleted.
EID-6013
NTP/SNTP server could not be changed.
{1}
Refer to the error message text.
EID-6014
Operation failed. The reference state is OOS.
Change the Out-of-service state to Active.
EID-6015
Distance Extension cannot be disabled if the port media type is
FICON 1Gbps ISL or FICON 2Gbps ISL.
Refer to the error message text.
EID-6016
Card mode cannot be changed to Fibre Channel Line Rate if the
port media type is FICON 1Gbps ISL or FICON 2Gbps ISL.
Refer to the error message text.
EID-6017
The destination of a {0} route cannot be a node IP address.
A node IP address cannot be the destination
for a static route.
EID-6018
The destination of a {0} route cannot be the same as the subnet
used by the node.
Refer to the error message text.
EID-6019
The destination of a static route cannot be 255.255.255.255
The network address such as
255.255.255.255 is not valid. Enter a valid
address.
EID-6020
The destination of a static route cannot be the loopback network
(127.0.0.0/8)
Refer to the error message text.
EID-6021
The subnet mask length for a non-default route must be
between 8 and 32.
Length of subnet mask must be within the
specified range.
EID-6022
The subnet mask length for a default route must be 0.
Refer to the error message text.
EID-6023
The destination of a {0} route cannot be an internal
network{1}.
The destination of a static route must not be
an internal network.
Table 1-1
Error Messages (continued)
Error Warning
ID
Error Warning Message
Description
