1-18
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
78-17235-01
Chapter 1 Error Messages
EID-3072
Clear Learned Address
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
EID-3073
Clear Selected Rows
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
EID-3074
Clear By {0}
Error encountered trying to clear the
learned MAC address from either a VLAN
or a port.
EID-3075
At least one row in param column needs to be selected.
Refer to the error message text.
EID-3076
CTC lost its connection with this node. The NE Setup Wizard
will exit.
Refer to the error message text.
EID-3077
No optical link selected.
Refer to the error message text.
EID-3078
Unable to create optical link.
Refer to the error message text.
EID-3079
Cannot apply defaults to node: {0}
CTC cannot apply the defaults to the
specified node.
EID-3080
Cannot go to the target tab {0}
CTC cannot go to the specified target tab.
EID-3081
Port type cannot be changed.
Refer to the error message text.
EID-3082
Cannot modify the {0} extension byte.
You cannot modify the specified extension
byte.
EID-3084
Error encountered while trying to retrieve laser parameters for
{0}
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
EID-3085
No OSC Terminations selected
Select an OSC termination and proceed.
EID-3086
One or more Osc terminations could not be created.
Refer to the error message text.
EID-3087
OSC termination could not be edited.
Refer to the error message text.
EID-3088
No {0} card to switch.
No card of the specified type to switch.
EID-3089
Cannot use/change {0} state when {1} is failed or missing.
Cannot use or change the specified state
when the card is failed or missing.
EID-3090
Cannot perform operation as {0} is
{1}LOCKED_ON/LOCKED_OUT.
Cannot perform operation.
EID-3091
Cannot perform the operation as protect is active.
Refer to the error message text.
EID-3092
Invalid service state. The requested action cannot be applied.
Select another service state and proceed.
EID-3093
Cannot perform the operation as duplex pair is {0}locked.
Refer to the error message text.
EID-3094
Cannot perform the operation as no XC redundancy is
available.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
EID-3095
Deletion failed since the circuit is in use
Refer to the error message text.
WID-3096
Internal communication error encountered while trying to
retrieve laser parameters. This can happen when equipment is
not present or when equipment is resetting. Check the
equipment state and try to refresh the values again.
Refer to the warning message text.
Table 1-1
Error Messages (continued)
Error Warning
ID
Error Warning Message
Description
