Cisco Nexus 5000 Series, Cli Configuration Manual, Page: 154 / 660

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
1-12
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
OL-16597-01
Chapter 1 Configuring MST
Configuring MST
To enter MST configuration mode, perform this task (note the difference between exit and abort ):
This example shows how to enter MST configuration submode on the switch:
switch# configure terminal
switch(config)# spanning-tree mst configuration
This example shows how to commit the changes and leave MST configuration submode on the switch:
sswitch(config-mst)# exit
This example shows how to leave MST-submode configuration on the switch without committing the
changes:
sswitch(config-mst)# abort
To disable MST configuration mode, perform this task:
Specifying the MST Name
You configure a region name on the bridge. For two or more bridges to be in the same MST region, they
must have the identical MST name, VLAN-to-instance mapping, and MST revision number.
Command Purpose
Step 1
switch# configure terminal
Enters configuration mode.
Step 2
switch(config)# spanning-tree mst
configuration
Enters MST configuration submode on the system.
You must be in the MST configuration submode to
assign the MST configuration parameters, as follows:
• MST name
•
Instance-to-VLAN mapping
• MST revision number
•
Synchronize primary and secondary VLANs in
private VLANs
Step 3
switch(config-mst)# exit
Commits all the changes and exits MST configuration
submode.
switch(config-mst)# abort Exits the MST configuration submode without
committing any of the changes.
Command Purpose
switch(config-mst)# no spanning-tree mst
configuration
Returns the MST region configuration to the
following default values:
•
The region name is an empty string.
• No VLANs are mapped to any MST instance (all
VLANs are mapped to the CIST instance).
•
The revision number is 0.