Required Tools and Equipment
•
Four M4 x 10 mm screws per power tray
•
6-inch, Number-2 Phillips screwdriver
•
Number-2 Phillips torque screwdriver with torque rated up to 55 in-lb (6.2 N-m)
•
AC or DC power tray
◦
AC power tray (Cisco PID NCS-AC-PWRTRAY)
◦
DC power tray (Cisco PID NCS-DC-PWRTRAY)
Steps
To install an AC or DC power tray, follow these steps:
Step 1
Using two people, one to support the power tray underneath and the other to keep it steady, lift the power tray up and
slide it partially into a power tray slot on the power enclosure.
Because of the weight of a power tray, 20 lb (9 kg), and the height at which a power tray is installed in the
FCC, be especially careful while removing and carrying a power tray. To prevent injury, avoid sudden twists
or lateral moves.
Caution
Step 2
Grasping both handles simultaneously, push both the left and right handles in at the same time to push the tray into the
power enclosure. Slide the tray all the way into the enclosure until both power tray handles engage the slots.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
19
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Installing an AC or DC Power Tray
