Usually, it is not necessary to remove the power enclosure although it is field-serviceable. For information
about removing the power enclosure components, see the
Replacing an AC or DC Power Tray, on page
99
section.
Note
Figure 5: FCC Power Enclosure
—
Front and Rear Views
PCM I/O power switches (one per PCM)
3
Four power tray slots for AC or DC power trays
1
Two PCMs
2
Installing the Power Enclosure
This section describes how to install the power enclosure in the Cisco NCS 6000 FCC.
Required Tools and Equipment
•
6-inch, Number-2 Phillips screwdriver
•
Power enclosure (Cisco PID NCS-F-PWR-SHELF)
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
14
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Installing the Power Enclosure