Table 13: Console Port Pinouts
Description
Direction
Signal Name
Pin
Aux Consoles transmit output,
RS232
Output
ACONS-TX
1
Receive TIP (T1/E1)
NA
NC
2
Console RS232 transmit
Output
CONS-TX
3
Ground
NA
Gnd
4
Ground
NA
Gnd
5
Console RS232 receive
Input
CONS-RX
6
Aux Consoles receive input, RS232
Input
ACONS-RTX
7
NA
NA
NC
8
Management Ethernet Port Pinouts
This following table summarizes the Management Ethernet port pinouts:
Table 14: Management and PTP Ethernet Port Pinouts
Signal Name
Pin
TRP0+
1
TRP0-
2
TRP1+
3
TRP1-
4
TRP2+
5
TRP2-
6
TRP3+
7
TRP3-
8
Timing Port Pinouts
The platform is capable of receiving or sourcing timing signals of 1 PPS & 10 MHz. These interfaces are
provided by two mini-coax 50-Ohm, 1.0/2.3 DIN series connector on the front panel. Similarly there are two
mini-coax 50-Ohm connectors provided in the front panel to output this 1PPS and 10MHz.
This table below summarizes the timing port pinouts:
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
70
Appendix
Management Ethernet Port Pinouts
