Step 4
Reenter the password.
When you enter the same password, the software accepts the password .
Step 5
Enter the IP address for the management interface.
Step 6
Enter a network mask for the management interface.
Step 7
The software asks whether you want to edit the configuration. Enter
no
to not edit the configuration.
Step 8
The software asks whether you want to save the configuration. Enter
yes
to save the configuration.
Verify Device Installation
After installing the Cisco NCS 540 Router, you use the
show
commands to verify the installation and
configuration. If any issue is detected, take corrective action before continuing with further configurations.
1. show inventory
Displays information about the field replaceable units (FRUs), including product IDs, serial numbers, and
version IDs.
Example:
#show inventory
2. admin show environment
Displays all environment-related router information.
Example:
#admin show environment
3. show environment temperature
Displays temperature readings for on-board temperature sensors and for PSU. Each temperature sensor
has three thresholds:
• Minor temperature threshold: When a minor threshold is exceeded, a minor alarm occurs and the
following actions occur for all sensors:
• System messages are displayed
• SNMP notifications (if configured) are sent
• Log environmental alarm event is triggered (Run the
show alarm
command to review this.)
• Major temperature threshold: When a major threshold is exceeded, a major alarm occurs and the
following actions occur for all sensors:
• System messages are displayed
• SNMP notifications (if configured) are sent
• Log environmental alarm event is triggered (Run the
show alarm
command to review this.)
• Critical temperature threshold: When a critical threshold is exceeded, a critical alarm occurs and the
following actions occurs:
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
59
Configure the Device
Verify Device Installation
