Cisco ME 3600X, Command Reference Manual

Page: 574 / 628

B-6
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Appendix B Cisco ME 3800X and ME 3600X Switch Debug Commands
debug interface
debug interface
To enable debugging of interface-related activities, use the debug interface command in privileged
EXEC mode. To disable debugging, use the no form of this command.
debug interface { interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id }
no debug interface { interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id }
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
Related Commands
interface-id Displays debug messages for the specified physical port, identified by type
switch number/module number/ port, for example
gigabitethernet 0/2 .
null interface-number Displays debug messages for null interfaces. The interface-number is always
0 .
port-channel
port-channel-number
Displays debug messages for the specified EtherChannel port-channel
interface. The
port-channel-number range is 1 to 26.
vlan vlan-id Displays debug messages for the specified VLAN. The vlan-id range is 1 to
4094.
Release Modification
12.2(52)EY This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show interface Displays interface status and configuration information.