Cisco ME 3600X, Command Reference Manual

Page: 282 / 628

-6
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
service-policy (interface and service-instance configuration modes)
service-policy (interface and service-instance configuration
modes)
To apply a policy map defined by the policy-map command to the incoming or outgoing traffic of a
target, use the service-policy command in interface configuration mode or service-instance
configuration mode. To remove the policy map and port association, use the no form of this command.
service-policy { input | output } policy-map-name
no service-policy { input | output } policy-map-name
Syntax Description
Defaults No policy maps are attached to the port or service instance.
Command Modes Interface configuration or service-instance configuration mode
Command History
Usage Guidelines
Only one input policy map and one output policy map can be attached to a target, which can be a physical
interface or Ethernet flow point service instance.
The switch supports a limit of three unique queue-limit configurations across all output policy maps at
any time. Multiple policy maps can share the same queue-limit configuration.If you try to attach an
output policy map with a fourth unique queue-limit configuration, you see this error message:
QoS: Configuration failed. Maximum number of allowable unique queue-limit
configurations exceeded.
You can attach input or output policy maps to a Gigabit Ethernet port 10 Gigabit Ethernet port or to a
service instance. You cannot attach policy maps to switch virtual interfaces (SVIs) and EtherChannel
interfaces.
You can verify the configuration by entering the show running-config privileged EXEC command.
input Applies the policy map to the input of a target (physical port or Ethernet
flow point (EFP) service instance.
output Applies the policy map to the output of a target.
policy-map-name The specified policy map to be applied.
Release Modification
12.2(52)EY This command was introduced.