2-37
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
OL-9641-04
Chapter 2 Messages and Recovery Procedures
PHY Messages
Error Message
%PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation
The switch could not add a function to the registry. [chars] is the registry name.
Recommended Action
No action is required.
PHY Messages
This section contains the PHY messages.
Error Message
PHY-4-BADTRANSCEIVER: An inappropriate transceiver has been inserted
in interface [chars].
Explanation
This message means that a transceiver that should not be used is in the specified
interface.
Recommended Action
Remove the transceiver. If the transceiver is a Cisco device, contact your Cisco
technical support representative.
Error Message
PHY-4-CHECK_SUM_FAILED: SFP EEPROM data check sum failed for SFP
interface [chars].
Explanation
This message means that the SFP module was identified as a Cisco SFP module, but the
system cannot read the vendor data information to verify whether it is correct. [chars] is the interface
in which the SFP module is installed.
Recommended Action
Remove and then reinsert the SFP module. If it fails again with the same error
message, the SFP module might be defective.
Error Message
PHY-4-EXCESSIVE_ERRORS: Excessive FCS, data, or idle word errors found
on interface [chars].
Explanation
This message means that the system detected excessive frame check sequence (FCS),
data word, or idle word errors on the specified interface. [chars] is the interface.
Recommended Action
Enter the
show interface
privileged EXEC command
on the specified
interface, and check for cyclic redundancy check (CRC) and other input errors. If errors are
excessive, enter the
shutdown
interface configuration command and then the
no shutdown
interface
configuration command to reset the interface.