Configuration Wizards
Using the Setup Wizard for the Initial Configuration
Cisco ISA500 Series Integrated Security Appliances Administration Guide
39
2
Validating Security License
STEP 10
Use the License Installation page to validate the security license, which is used to
activate security services on the device.
STEP 11
If the security license is already installed on the security appliance, click
Next
to
proceed next step.
STEP 12
If the security license is not installed on the security appliance, enter the following
information to validate the security license:
•
Email Address:
Enter the registered email address to receive the PAK ID.
•
PAK ID:
Enter your Product Authorization Key in this field. You can find the
license code from the Software License Claim Certificate that Cisco
provides upon purchase of the security appliance.
NOTE:
A valid Cisco.com account is required to validate the security license.
If your Cisco.com account credentials are not configured, go back to the
Cisco.com Credentials page to configure them.
NOTE:
If you want to continue the Setup Wizard configuration without installing the
security license, check the box next to
Continue without installing license (not
recommended)
. The security services cannot be activated without installing the
security license.
STEP 13
After you are finished, click
Next
.
Enabling Bonjour and CDP Discovery Protocols
STEP 14
Use the Discovery page to enable Bonjour and/or CDP discovery protocols on the
security appliance. For optimal device discovery and topology support via the
OnPlus portal, enable both discovery protocols.
•
Enable Bonjour Discovery Protocol:
Check this box to enable Bonjour
discovery protocol, or uncheck this box to disable it.
•
Enable Cisco Discovery Protocol (CDP):
Check this box to enable Cisco
Discovery Protocol (CDP), or uncheck this box to disable it.
NOTE:
Discovery protocols are only operational on the LAN ports of the
security appliance.
STEP 15
After you are finished, click
Next
.
