Figure 36: Attaching the Brackets to the DIN Rail
Step 1
Position the Device so that the lower edge and spring of the Din clips (
1
) engages with the bottom section of the Din rail
(
2
).
Step 2
Push up on the Device so that the spring of DIN clips (
1
) compresses against the lower section of DIN rail (
2
) and then
rotate the Device so that the top hook of the DIN clips (
1
) clamps to the top section of DIN rail (
2
).
Step 3
To remove the Device from the DIN Rail, simply reverse the procedure.
IR1101 Industrial Integrated Services Router Hardware Installation Guide
60
Installing the IRM-1100 Expansion Module
Attaching the Bracket Onto the DIN Rail
