Cisco IE 4000, Software Configuration Manual

Page: 919 / 1066

915
Configuring IP Unicast Routing
Configuring Protocol-Independent Features
DETAILED STEPS
To disable redistribution, use the no form of the commands.
EXAMPLE
Given the following configuration, a RIP-learned route for network 160.89.0.0 and an ISO IGRP-learned route with prefix
49.0001.0002 will be redistributed into an IS-IS Level 2 link-state PDU with metric 5:
router isis
redistribute rip route-map ourmap
redistribute iso-igrp remote route-map ourmap
route-map ourmap permit
match ip address 1
match clns address ourprefix
set metric 5
set level level-2
access-list 1 permit 160.89.0.0 0.0.255.255
clns filter-set ourprefix permit 49.0001.0002...
Configuring Policy-Based Routing
You can use policy-based routing (PBR) to configure a defined policy for traffic flows. By using PBR, you can have more
control over routing by reducing the reliance on routes derived from routing protocols. PBR can specify and implement
routing policies that allow or deny paths based on:

Identity of a particular end system

Application

Protocol
Command Purpose
1. configure terminal Enter global configuration mode.
2. router { bgp | rip | ospf | eigrp } Enter router configuration mode.
3. redistribute protocol [ process-id ] { level-1 |
level-1-2 | level-2 } [ metric metric-value ]
[ metric-type type-value ] [ match internal | external
t ype-value ] [ tag tag-value ] [ route-map map-tag ]
[ weight weight ] [ subnets ]
Redistribute routes from one routing protocol
to another routing protocol. If no route-maps
are specified, all routes are redistributed. If the
keyword
route-map is specified with no
map-tag , no routes are distributed.
4. default-metric number Cause the current routing protocol to use the
same metric value for all redistributed routes
(BGP, RIP, and OSPF).
5. default-metric bandwidth delay reliability loading
mtu
Cause the EIGRP routing protocol to use the
same metric value for all non-EIGRP
redistributed routes.
6. end Return to privileged EXEC mode.
7. show route-map Display all route maps configured or only the
one specified to verify configuration.
8. copy running-config startup-config (Optional) Save your entries in the
configuration file.