Figure 34. Configurator (Advanced Radio Settings menu)
Using the FluidMAX Management Setting
The
FluidMAX™ Management
controls are used to set the unit's
FluidMAX™ operating mode.
Note that the
FluidMAX™ Management
controls are only available under
the following conditions:
• If the unit's firmware is equipped with the FluidMAX engine.
• If the unit is currently being operated as part of a point-to-multipoint
network topology.
To use the FluidMAX Management menu, do the following steps:
1.
Click the
Radio Mode
drop-down menu.
2.
Choose the correct FluidMAX operating mode from the following
list of options:
•
AUTO:
The FluidMAX engine is enabled, and the unit role
is set automatically. Depending on various factors, the unit
will automatically choose whether to transmit using the
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 89 of 176
