8. Troubleshooting
This section contains information that will allow you to solve common
problems associated with configuration and installation of Cisco
products.
8.1. I cannot get the Log-in screen
If you have directly connected a Windows computer to your Cisco
device for device configuration, but you cannot access the log-in form on
your web browser, check the following points:
Are you trying to access the unit using a valid IP address?
You must manually set the computer's IP address and Netmask to be
recognizable by the Cisco device. The correct settings are as follows:
•
IP address:
192.168.0.10 (or any other IP address belonging to
subnet 192.168.0.0/255.255.255.0)
•
Netmask:
255.255.255.0
Have you disabled the 'Access the Internet using a proxy server' function?
If your browser shows a time-out or similar message, the computer may
be trying to access the Cisco device through a proxy server. To stopthe
computer from trying to access the unit through a proxy connection,
refer to
“Accessing the Cisco FM3200 Base for device configuration”
8.2. I cannot log in to the FM Racer interface
IMPORTANT
For a detailed description of the differences between the FM
Racer configuration interface and the local Configurator
interface, refer to
“Device configuration using the configurator
.
If you are not able to log in to the FM Racer web-based configuration
interface, check that you have entered the correct user name and
password.
The factory-set user name for the FM Racer configuration interface is
admin
. The factory-set password is
admin
To change the factory-set user name and
to
refer
password,
the
Cisco Networks FM Racer User Manual
.
8.3. I forgot the Administrator password
If you have forgotten the Administrator user name and/or password for the
Configurator interface, and you must access the unit to configure it using
the Configurator interface, do the following steps:
Troubleshooting
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 155 of 176
