10
Step 1
Position the phone so that the front of the phone is
facing up.
Step 2
Line up the two open slots on the bottom of the
Expansion Module 7914 with the two hooks on the
support bar.
Step 3
Insert the hooks into the slots and then rotate the top
of the Expansion Module 7914 into the support bar so
that it rests flush with the bar.
Step 4
Tighten the thumbscrew on the back of the
Expansion Module 7914.
Note
If you are installing two Expansion Modules,
repeat Steps 2, 3, and 4 for the second
Expansion Module.
Connect the Interface Cable
Refer to the following table, which depicts the “in” and “out”
icons on the AUX jacks, and to Figure 5 and the steps that
follow.
Note
On your Cisco IP Phone or Expansion Module 7914,
the AUX jack may be labelled RS-232. In this case read
“RS-232 jack” for AUX jack in Figure 5 and Steps 1 –
4 in this section.
In icon
Out icon
