IP Access Control
4030765 Rev 01
51
IP Access Control
The IP Address Access Control mode, if enabled, permits access to local
management services from IP addresses contained in the Access Control List. If the
Access Control mode is disabled, you cannot configure the residential gateway from
non-local IP addresses. For example, you can use this feature to prevent a remote site
from configuring the residential gateway. The services are the system applications
listed in the Service Control List.
Path
: System > Management > Settings > IP Access Control
Adding IP Address Access Control
To add IP address access control, complete the following steps.
1
Click
System
on the main screen. The System Summary screen opens by default.
3-6-2009 Draft
Summary of Contents for DDR2201 Series
Page 2: ...3 6 2009 Draft ...
Page 32: ...3 6 2009 Draft ...
