15-28
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
OL-27038-01
Chapter 15 First-Time Setup
Setting Up CTS Components
Note
The Cisco TelePresence System can display information from multiple input devices during a meeting;
if multiple input devices are sending information, the display shows the input from the last presentation
display sending information. If you do not see an input device image, try the following: for VGA devices,
unplug the device from the VGA cable, wait 5 seconds, and then plug the device back in; for document
cameras: turn the camera off, wait 5 seconds, and then restart the device.
Other Devices
Use
Other Devices
to check the Auxiliary Control Unit, which controls the light units surrounding the
displays, and enables the CTS to get more complete presentation display status information and restore
presentation display defaults.
•
Click
Other Devices
on the Hardware Setup window.
•
Click the
Start
radio button to access the Auxiliary Control Unit to begin testing. To end the test,
click
Stop
.
–
Individual light units correspond to the five port numbers of the Auxiliary Control Unit. Click
the appropriate box to select a specific port number; Click
Select All
to select all ports (and all
light units) or
Select None
.
–
Click the
Refresh On/Off Status
button to update the on/off status of each port.
–
Click the
Turn Selected Lights On/Off
to test the selected light unit(s).
–
Click the
Reset Auxiliary Control Unit
to power cycle the Auxiliary Control Unit.
