To display the platform hardware throughput monitor settings, use the
show platform hardware
throughput-monitor parameters
command, as shown in the following example:
Router#
show platform hardware throughput-monitor parameters
Throughput monitor parameters
Throughput monitor threshold: 95 percent
Throughput monitor interval: 300 seconds
Throughput monitor status: enabled
The following example shows a console log message received when the average throughput has exceeded 95
percent of the maximum throughput with a sample period of 300 seconds:
Dec 13 22:00:29.699: %BW_LICENSE-3-THROUGHPUT_THRESHOLD_LEVEL: F0: cpp_ha: Average
throughput rate exceeded 95 percent of licensed bandwidth 3 times, sample
period 300 seconds, in last 24 hours
The following example shows a console log message received when the average throughput approaches
maximum allowed throughput set by the installed license:
Dec 13 22:00:29.699: %BW_LICENSE-4-THROUGHPUT_MAX_LEVEL: F0: cpp_ha: Average
throughput rate exceeded the total licensed bandwidth 50000000 bps and dropped
packets 7 times, sample period 300 seconds, in last 24 Hours
To disable the platform hardware throughput monitor, perform the following command:
set platform hardware throughput-monitor disable
Requesting a New Virtual UDI
The Cisco CSR 1000v license is node-locked to the vUDI. If you clone the Cisco CSR 1000v to a new VM
instance, the vUDI is in most cases automatically updated when the router first boots up on the cloned machine.
However, if the vUDI is not automatically updated, you must manually request a new vUDI on the cloned
VM instance.
Requesting a new vUDI will invalidate the existing license. If you later need to rehost the license due to
a system failure, you may need to perform additional steps on the Cisco Software Licensing portal. For
more information on rehosting the Cisco CSR 1000v license, see
Voluntarily Rehosting the License to a
New VM, on page 299
and
Obtaining a Rehost License if the System Fails, on page 301
.
Caution
Perform the following step in EXEC mode:
SUMMARY STEPS
1.
request license new-udi
DETAILED STEPS
Purpose
Command or Action
Requests that a new virtual UDI be assigned to the Cisco
CSR 1000v VM instance.
request license new-udi
Example:
Router# request license new-udi
Step 1
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
192
Installing Cisco CSR 1000v Licenses
Requesting a New Virtual UDI
