Example:
Router# reload
Restarts the Cisco CSR 1000v to enable the feature set and the maximum throughput supported by the license.
Note: If you are installing an AX license, you do not need to restart the Cisco CSR 1000v.
Step 11
show license detail
Example:
The following is an example of the
show license detail
command showing an installed active license:
Router#
show license detail
Index: 1
Feature: sec_100M
Version: 1.0
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Store Index: 0
Store Name: Primary License Storage
Displays the license information.
Step 12
platform hardware throughput level MB
{
10 | 100 | 1000 | 10000 | 250 | 2500 | 50 | 500 | 5000
}
Example:
Router(config)# platform hardware throughput level 500
(Optional) Changes the maximum throughput level for the Cisco CSR 1000v.
Note: After this command, you do not need to restart the Cisco CSR 1000v.
What to Do Next
Repeat these steps for each license available for your PAK.
Configuring an Interface for 10 Gbps Maximum Throughput
If you installed a license with maximum throughput with 10 Gbps, then additional configuration is required
to obtain the 10 Gbps throughput on an interface. Perform the following additional steps.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface GigabitEthernet number
4.
no negotiation auto
5.
speed 10000
Cisco CSR 1000v Series Cloud Services Router Software Configuration Guide
161
Installing Cisco CSR 1000v Licenses
Configuring an Interface for 10 Gbps Maximum Throughput
