Configuring the mLDP User Interface to Filter Label Mappings
SUMMARY STEPS
1.
configure
2.
mpls ldp mldp
3.
address-family ipv4
4.
neighbor
[
ipv4 ip address
]
route-policy mldp_policy in | out
5.
end-policy
6.
commit
7.
Use the show command to verify the configuration: show running-config route-policy mldp_policy
DETAILED STEPS
Purpose
Command or Action
Enters global configuration mode.
configure
Example:
RP/0/RP0/CPU0:router#
configure
Step 1
Enters the LDP configuration mode.
mpls ldp mldp
Example:
RP/0/RP0/CPU0:router(config)#
mpls ldp mldp
Step 2
Enters the MLDP address family configuration mode.
address-family ipv4
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)#
address-family ipv4
Step 3
Configures the specified neighborhood IPv4 IP
address to the MLDP policy as either inbound or
outbound route policy.
neighbor
[
ipv4 ip address
]
route-policy mldp_policy in | out
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)#
neighbor
ipv4 ip address route-policy mldp_policy in | out
Step 4
end-policy
Step 5
Example:
RP/0/RP0/CPU0:router(config-ldp-mldp)# end-policy
commit
Step 6
Example outputs are as shown:
Wed Jun 18 11:41:09.333 IST
Use the show command to verify the configuration: show
running-config route-policy mldp_policy
Step 7
mpls ldp
mldp
neighbor route-policy mldp_policy out
!
mpls ldp
mldp
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
54
Implementing Multicast Routing on Cisco IOS XR Software
Multipoint Label Distribution Protocol Route Policy Map