interface TenGigabitEthernet0/0/1
!
interface TenGigabitEthernet0/0/2
!
interface TenGigabitEthernet0/0/3
!
interface GigabitEthernet0
no shutdown
ip address 10.104.33.77 255.255.255.0
no mop enabled
!
interface Vlan1
shutdown
no ip address
!
end
To ensure that the correct subnet is allotted by the user, see the
Gigabit Ethernet Management Interface
Overview
section.
Note
Step 10
Respond to the following prompts. Select [
2
] to save the initial configuration.
[0]
Go to the IOS command prompt without saving this config.
[1]
Return back to the setup without saving this config.
[2]
Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
The following user prompt is displayed:
myWLC#
Completing the Configuration
When using the Cisco setup command facility, and after you have provided all the information requested by
the facility as described in
Using the Cisco setup Command Facility
section, the final configuration appears.
To complete your controller configuration, follow these steps.
Step 1
The facility prompts you to save the configuration.
• If you answer no, the configuration information you entered is not saved, and you return to the controller enable
prompt (
WLC#
). Enter
setup
to return to the System Configuration dialog box.
• If you answer yes, the configuration is saved, and you are returned to the user EXEC prompt (
WLC>
).
Use this configuration? {yes/no} :
yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
%LINK-3-UPDOWN: Interface GigabitEthernet0/1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1/0, changed state to up
<Additional messages omitted.>
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
59
Power Up and Initial Configuration
Completing the Configuration
