21-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Chapter 21 Configuring SmartPort Macros
Configuring SmartPort Macros
•
When you apply a macro to a switch or a switch interface, the macro name is automatically added
to the macro description of the switch or interface. You can display the applied commands and macro
names by using the
show parser macro description
user EXEC command.
•
The user-configurable macro has a buffer that can take commands and comments up to 3000
characters. Each new line takes two characters, and empty lines are counted as is.
Cisco-default SmartPort macros are embedded in the switch software (see
). You can display
these macros and the commands they contain by using the
show parser macro
user EXEC command.
Follow these guidelines when you apply a Cisco-default SmartPort macro on an interface:
•
Display all macros on the switch by using the
show parser macro
user EXEC command. Display
the contents of a specific macro by using the
show parser macro
macro-name
user EXEC
command.
•
Keywords that begin with
$
mean that a unique parameter value is required. Append the
Cisco-default macro with the required values by using the
parameter
value
keywords.
The Cisco-default macros use the
$
character to help identify required keywords. There is no
restriction on using the
$
character to define keywords when you create a macro.
Creating SmartPort Macros
To create a SmartPort macro, perform this task:
Command
Purpose
Step 1
Switch#
configure terminal
Enters global configuration mode.
Step 2
Switch(config)#
macro name
macro-name
Creates a macro definition, and enter a macro name. A macro definition
can contain up to 3000 characters.
Enter the macro commands with one command per line. Use the
@
character to end the macro. Use the
#
character at the beginning of a line
to enter comment text within the macro.
Macro names are case sensitive. For example, the commands
macro
name Sample-Macro
and
macro name sample-macro
result in two
separate macros.
We recommend that you do not use the
exit
or
end
commands or change
the command mode by using
interface
interface-id
in a macro. This
could cause any commands following
exit
,
end
, or
interface
interface-id
to execute in a different command mode. For best results,
all commands in a macro should be in the same configuration mode.
Note
The
no
form of the
macro name
global configuration command
only deletes the macro definition. It does not affect the
configuration of those interfaces on which the macro is already
applied.
Step 3
Switch(config)#
end
Returns to privileged EXEC mode.
Step 4
Switch#
show parser macro
name
macro-name
Verifies that the macro was created.
Summary of Contents for Catalyst 4500 Series
Page 2: ......
Page 4: ......
Page 2086: ...Index IN 46 Software Configuration Guide Release IOS XE 3 9 0E and IOS 15 2 5 E ...
