2-308
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
mls qos srr-queue output cpu-queue
mls qos srr-queue output cpu-queue
Use the
mls qos srr-queue output cpu queue
global configuration command to assign CPU-generated
control plane packets to an egress queue and to specify the threshold values. Use the
no
form of this
command to return to the default setting.
mls qos srr-queue output cpu queue
queue-id
threshold
threshold-id
no mls qos srr-queue output cpu queue
queue -d
threshold
threshold-id
Syntax Description
Defaults
The default egress queue value is 2.
Command Modes
Global configuration
Command History
Usage Guidelines
Use this command to specify an egress queue and a threshold ID for CPU-generated traffic.
You can assign each packet that flows through the switch to a queue and to a threshold. Specifically, you
map Differentiated Services Code Value (DSCP) or Class of Service (CoS) values to an egress queue-set
and map DSCP or CoS values to a threshold ID. You use the
mls qos srr-queue output dscp-map queue
queue-id
{
dscp1...dscp8
|
threshold
threshold-id dscp1...dscp8
} or
the
mls qos srr-queue output
cos-map queue
queue-id
{
cos1...cos8
|
threshold
threshold-id cos1...cos8
} global configuration
command. When you mark a CPU-generated control plane packet with a DSCP or CoS value, you can map
traffic to any of the four egress queues.
Examples
This example shows how to specify an egress queue for CPU-generated traffic. In this example, the
traffic is sent from queue 2 and has a threshold ID of 1.
Switch(config)#
mls qos srr-queue output cpu queue 2 threshold 1
Switch(config)#
cpu traffic qos dscp 20
Note that threshold 3 specifically applies to CPU-generated traffic. For example: If you explicitly issue
the
mls qos srr-queue output cpu queue 3 threshold 3
command, then traffic is always sent through
queue 3 regardless of the
dscp-map
or
cpu traffic qos
marking settings.
You can verify your settings by entering the
show mls qos maps
, the
show mls qos interface
[
interface-id
]
buffers
, or the
show mls qos queue-set
privileged EXEC commands.
queue
queue-id
Specify an egress queue and ID. The range is 1 to 4.
threshold
threshold-id
Specify a threshold value and ID. The range is 1 to 3.
Release
Modification
12.2(44)SE
This command was introduced.
