2-239
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
location (interface configuration)
location (interface configuration)
Use the
location interface
command to enter location information for an interface. Use the
no
form of
this command to remove the interface location information.
location
{
additional-location-information
word
|
civic-location-id
id
|
elin-location-id
id
}
no location
{
additional-location-information
word
|
civic-location-id
id
|
elin-location-id
id
}
Syntax Description
Defaults
This command has no default setting.
Command Modes
Interface configuration
Command History
Usage Guidelines
After entering the
location civic-location-id
id
interface configuration command, you enter civic
location configuration mode. In this mode, you can enter the additional location information.
The civic-location identifier must not exceed 250 bytes.
additional-location-information
Configure additional information for a location or place.
word
Specify a word or phrase that provides additional location
information.
civic-location-id
Configure global civic location information for an interface.
elin-location-id
Configure emergency location information for an interface.
id
Specify the ID for the civic location or the elin location. The ID
range is 1 to 4095.
Note
The identifier for the civic location in the LLDP-MED
TLV is limited to 250 bytes or less. To avoid error
messages about available buffer space during switch
configuration, be sure that the total length of all
civic-location information specified for each
civic-location ID does not exceed 250 bytes.
Release
Modification
12.2(40)SE
This command was introduced.
