2-165
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
ip igmp filter
ip igmp filter
Use the
ip igmp filter
interface configuration command to control whether or not all hosts on a Layer 2
interface can join one or more IP multicast groups by applying an Internet Group Management Protocol
(IGMP) profile to the interface. Use the
no
form of this command to remove the specified profile from
the interface.
ip igmp filter
profile number
no ip igmp filter
Syntax Description
Defaults
No IGMP filters are applied.
Command Modes
Interface configuration
Command History
Usage Guidelines
You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples
This example shows how to apply IGMP profile 22 to a port.
Switch(config)#
interface gigabitethernet1/0/2
Switch(config-if)#
ip igmp filter 22
You can verify your setting by using the
show running-config
privileged EXEC command and by
specifying an interface.
profile number
The IGMP profile number to be applied. The range is 1 to 4294967295.
Release
Modification
12.1(14)AX
This command was introduced.