2-96
Catalyst 3750 Metro Switch Command Reference
OL-9645-10
Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands
dot1x timeout
dot1x timeout
Use the
dot1x timeout
interface configuration command to set 802.1x timers. Use the
no
form of this
command to return to the default setting.
dot1x timeout
{
quiet-period
seconds
|
reauth-period
seconds
|
server-timeout
seconds
|
supp-timeout
seconds
|
tx-period
seconds
}
no dot1x timeout
{
quiet-period
|
reauth-period
|
server-timeout
|
supp-timeout
|
tx-period
}
Syntax Description
Defaults
These are the default settings:
reauth-period
is 3600 seconds.
quiet-period
is 60 seconds.
tx-period
is 30 seconds.
supp-timeout
is 30 seconds.
server-timeout
is 30 seconds.
Command Modes
Interface configuration
Command History
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
quiet-period
seconds
Number of seconds that the switch remains in the quiet state following a
failed authentication exchange with the client. The range is 1 to 65535.
reauth-period
seconds
Number of seconds between re-authentication attempts. The range is 1to
65535.
server-timeout
seconds
Number of seconds that the switch waits for the retransmission of packets
by the switch to the authentication server. The range is 1 to 65535.
However, we recommend a minimum setting of 30.
supp-timeout
seconds
Number of seconds that the switch waits for the retransmission of packets
by the switch to the 802.1x client. The range is 30 to 65535.
tx-period
seconds
Number of seconds that the switch waits for a response to an
EAP-request/identity frame from the client before resending the request.
The range is 1 to 65535.
Release
Modification
12.1(14)AX
This command was introduced.
12.2(40)SE
The range for
tx-period
seconds is incorrect. The correct range is from 1 to
65535.
