Cisco Catalyst 3560, Hardware Installation Manual

Page: 57 / 168

2-13
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Chapter 2 Product Overview
Rear Panel Description
Power Connectors
The switch is powered through the internal power supply. You can also connect
the Cisco RPS 675 to provide backup power if the switch internal power supply
should fail.
Note
The Catalyst 3560 switch and the RPS 675 should be connected to the same AC
power source.
Internal Power Supply Connector
The internal power supply is an autoranging unit that supports input voltages
between 100 and 240 VAC. Use the supplied AC power cord to connect the AC
power connector to an AC power outlet.
Cisco RPS Connector
The switch is powered through the internal power supply. You can also connect
the Cisco 675 Redundant Power System (model PWR675-AC-RPS-N1=) to
provide backup power if the switch internal power supply should fail.
Note
The Catalyst 3560 switch and the Cisco RPS 675 should be connected to the same
AC power source.
Cisco RPS 675
The Cisco RPS 675 has two output levels: –48 V and 12 V, with a total maximum
output power of 675 W. Use the supplied RPS connector cable to connect the RPS
to the switch.
Warning
Attach only the Cisco RPS (model PWR675-AC-RPS-N1=) to the RPS receptacle.