Cisco Catalyst 3560-X Series, Software Configuration Manual

Page: 344 / 1538

1-56
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Authentication
Creating an LLDP Filter
Beginning in privileged EXEC mode, follow these steps to create an LLDP filter containing a list of
TLVs that can be included or excluded in the Device Sensor output:
Creating a DHCP Filter
Beginning in privileged EXEC mode, follow these steps to create a DHCP filter containing a list of
DHCP options that can be included or excluded in the Device Sensor output:
Command Purpose
Step 1 configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 2 device-sensor filter-list lldp list
tlv-list-name
Example:
Switch(config)# device-sensor
filter-list lldp list lldp-list
Creates a TLV list and enters LLDP sensor configuration mode, where
you can configure individual TLVs.
Step 3 tlv { name tlv-name | number tlv-number }
Example:
Switch(config-sensor-cdplist)# tlv
number 10
Adds individual LLDP TLVs to the TLV list. You can delete the TLV
list without individually removing TLVs from the list by using the
no
device-sensor filter-list lldp list tlv-list-name command.
Step 4 end
Example:
Switch(config-sensor-lldplist)# end
Returns to privileged EXEC mode.
Command Purpose
Step 1 configure terminal
Example:
Switch# configure terminal
Enters global configuration mode.
Step 2 device-sensor filter-list dhcp list
option-list-name
Example:
Switch(config)# device-sensor
filter-list dhcp list dhcp-list
Creates an options list and enters DHCP sensor configuration mode,
where you can specify individual DHCP options.