38-16
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 38 Configuring IP Unicast Routing
Configuring IP Addressing
Forwarding UDP Broadcast Packets and Protocols
User Datagram Protocol (UDP) is an IP host-to-host layer protocol. UDP provides a connectionless
session between two end systems and does not acknowledge received datagrams. Network hosts can use
UDP broadcasts to find address, configuration, and name information. If such a host is on a network
segment that does not include a server, UDP broadcasts might not be forwarded. However, you can
configure an interface on a router to forward certain broadcast classes to a helper address. You can use
more than one helper address per interface.
You can specify a UDP destination port to control which UDP services are forwarded. You can specify
multiple UDP protocols. You can also specify the Network Disk Protocol (NDP), which is used by older
diskless Sun workstations and the network security protocol SDNS.
By default, both UDP and NDP forwarding are enabled if a helper address has been defined for an
interface. The description for the
ip forward-protocol
interface configuration command in the
Cisco
IOS IP Command Reference, Volume 1 of 3: Addressing and Services, Release 12.2
lists the ports that
are forwarded by default if you do not specify any UDP ports.
If you do not specify any UDP ports when you configure the forwarding of UDP broadcasts, you are
configuring the router to act as a BOOTP forwarding agent. BOOTP packets carry DHCP information.
Beginning in privileged EXEC mode, follow these steps to enable forwarding of UDP broadcast packets
on an interface and to specify the destination address:
Use the
no ip helper-address
interface configuration command to disable the forwarding of broadcast
packets to specific addresses. Use the
no ip forward-protocol
global configuration command to remove
a protocol or port.
Establishing an IP Broadcast Address
The IP broadcast address (and the default) is an address consisting of all ones (255.255.255.255).
However, the switch can be configured to generate any form of IP broadcast address.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface
interface-id
Enter interface configuration mode, and specify the Layer 3 interface
to configure.
Step 3
ip helper-address
address
Enable forwarding and specify the destination address for forwarding
UDP broadcast packets, including BOOTP.
Step 4
exit
Return to global configuration mode.
Step 5
ip forward-protocol
{
udp
[
port
]
| nd | sdns
} Specify which protocols the router forwards when forwarding
broadcast packets.
Step 6
end
Return to privileged EXEC mode.
Step 7
show ip interface
[
interface-id
]
or
show running-config
Verify the configuration on the interface or all interfaces.
Step 8
copy running-config startup-config
(Optional) Save your entries in the configuration file.
