2-6
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 2 Using the Command-Line Interface
Using Editing Features
Recalling Commands
To recall commands from the history buffer, perform one of the actions listed in
. These actions
are optional.
Disabling the Command History Feature
The command history feature is automatically enabled. You can disable it for the current terminal session
or for the command line. These procedures are optional.
To disable the feature during the current terminal session, enter the
terminal no history
privileged
EXEC command.
To disable command history for the line, enter the
no history
line configuration command.
Using Editing Features
This section describes the editing features that can help you manipulate the command line. It contains
these sections:
•
Enabling and Disabling Editing Features, page 2-6
(optional)
•
Editing Commands through Keystrokes, page 2-7
(optional)
•
Editing Command Lines that Wrap, page 2-8
(optional)
Enabling and Disabling Editing Features
Although enhanced editing mode is automatically enabled, you can disable it, re-enable it, or configure
a specific line to have enhanced editing. These procedures are optional.
To globally disable enhanced editing mode, enter this command in line configuration mode:
Switch (config-line)#
no editing
Table 2-4
Recalling Commands
Action
1
1.
The arrow keys function only on ANSI-compatible terminals such as VT100s.
Result
Press
Ctrl-P
or the up arrow key.
Recall commands in the history buffer, beginning with the most recent command.
Repeat the key sequence to recall successively older commands.
Press
Ctrl-N
or the down arrow key.
Return to more recent commands in the history buffer after recalling commands
with
Ctrl-P
or the up arrow key. Repeat the key sequence to recall successively
more recent commands.
show history
While in privileged EXEC mode, list the last several commands that you just
entered. The number of commands that appear is controlled by the setting of the
terminal history
global configuration command and the
history
line configuration
command.
