13-32
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 13 Configuring VLANs
Configuring VMPS
This is an example of output for the
show vmps
privileged EXEC command:
Switch#
show vmps
VQP Client Status:
--------------------
VMPS VQP Version: 1
Reconfirm Interval: 60 min
Server Retry Count: 3
VMPS domain server: 172.20.128.86 (primary, current)
172.20.128.87
Reconfirmation status
---------------------
VMPS Action: other
Troubleshooting Dynamic-Access Port VLAN Membership
The VMPS shuts down a dynamic-access port under these conditions:
•
The VMPS is in secure mode, and it does not allow the host to connect to the port. The VMPS shuts
down the port to prevent the host from connecting to the network.
•
More than 20 active hosts reside on a dynamic-access port.
To re-enable a disabled dynamic-access port, enter the
shutdown
interface configuration command
followed by the
no shutdown
interface configuration command.
VMPS Configuration Example
shows a network with a VMPS server switch and VMPS client switches with
dynamic-access ports. In this example, these assumptions apply:
•
The VMPS server and the VMPS client are separate switches.
•
The Catalyst 6500 series Switch A is the primary VMPS server.
•
The Catalyst 6500 series Switch C and Switch J are secondary VMPS servers.
•
End stations are connected to the clients, Switch B and Switch I.
•
The database configuration file is stored on the TFTP server with the IP address 172.20.22.7.
