9-21
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 9 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
Note
If an EAPOL packet is detected after the interface has changed to the guest VLAN, the interface reverts
to an unauthorized state, and 802.1x authentication restarts.
Any number of 802.1x-incapable clients are allowed access when the switch port is moved to the guest
VLAN. If an 802.1x-capable client joins the same port on which the guest VLAN is configured, the port
is put into the unauthorized state in the user-configured access VLAN, and authentication is restarted.
Guest VLANs are supported on 802.1x ports in single-host or multiple-hosts mode.
You can configure any active VLAN except an RSPAN VLAN, a private VLAN, or a voice VLAN as an
802.1x guest VLAN. The guest VLAN feature is not supported on internal VLANs (routed ports) or
trunk ports; it is supported only on access ports.
The switch supports
MAC authentication bypass
. When MAC authentication bypass is enabled on
an 802.1x port, the switch can authorize clients based on the client MAC address when IEEE 802.1x
authentication times out while waiting for an EAPOL message exchange. After detecting a client on
an 802.1x port, the switch waits for an Ethernet packet from the client. The switch sends the
authentication server a RADIUS-access/request frame with a username and password based on the MAC
address. If authorization succeeds, the switch grants the client access to the network. If authorization
fails, the switch assigns the port to the guest VLAN if one is specified. For more information, see
the
“802.1x Authentication with MAC Authentication Bypass” section on page 9-26
.
For more information, see the
“Configuring a Guest VLAN” section on page 9-49
.
802.1x Authentication with Restricted VLAN
You can configure a restricted VLAN (also referred to as an
authentication failed VLAN
) for each
IEEE 802.1x port on a switch stack or a switch to provide limited services to clients that cannot access
the guest VLAN. These clients are 802.1x-compliant and cannot access another VLAN because they fail
the authentication process. A restricted VLAN allows users without valid credentials in an authentication
server (typically, visitors to an enterprise) to access a limited set of services. The administrator can
control the services available to the restricted VLAN.
Note
You can configure a VLAN to be both the guest VLAN and the restricted VLAN if you want to provide
the same services to both types of users.
Without this feature, the client attempts and fails authentication indefinitely, and the switch port remains
in the spanning-tree blocking state. With this feature, you can configure the switch port to be in the
restricted VLAN after a specified number of authentication attempts (the default value is 3 attempts).
The authenticator counts the failed authentication attempts for the client. When this count exceeds the
configured maximum number of authentication attempts, the port moves to the restricted VLAN. The
failed attempt count increments when the RADIUS server replies with either an
EAP failure
or an empty
response without an EAP packet. When the port moves into the restricted VLAN, the failed attempt
counter resets.
Users who fail authentication remain in the restricted VLAN until the next re-authentication attempt. A
port in the restricted VLAN tries to re-authenticate at configured intervals (the default is 60 seconds). If
re-authentication fails, the port remains in the restricted VLAN. If re-authentication is successful, the
port moves either to the configured VLAN or to a VLAN sent by the RADIUS server. You can disable
re-authentication. If you do this, the only way to restart the authentication process is for the port to
