39-23
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
OL-12247-04
Chapter 39 Configuring IPv6 Unicast Routing
Configuring IPv6
To disable a RIP routing process, use the
no
ipv6 router rip
name
global configuration command. To
disable the RIP routing process for an interface, use the
no ipv6 rip
name
interface configuration
command.
This example shows how to enable the RIP routing process
cisco
with a maximum of eight equal-cost
routes and to enable it on an interface:
Switch(config)#
ipv6 router rip cisco
Switch(config-router)#
maximum-paths 8
Switch(config)#
exit
Switch(config)#
interface gigabitethernet2/0/1
Switch(config-if)#
ipv6 rip cisco enable
For more information about configuring RIP routing for IPv6, see the “Implementing RIP for IPv6”
chapter in the
Cisco IOS IPv6 Configuration Library
on Cisco.com
Configuring OSPF for IPv6
You can customize OSPF for IPv6 for your network. However, the defaults for OSPF in IPv6 are set to
meet the requirements of most customers and features.
Follow these guidelines:
•
Be careful when changing the defaults for IPv6 commands. Changing the defaults might adversely
affect OSPF for the IPv6 network.
•
Before you enable IPv6 OSPF on an interface, you must enable routing by using the
ip routing
global configuration command, enable the forwarding of IPv6 packets by using the
ipv6
unicast-routing
global configuration command, and enable IPv6 on Layer 3 interfaces on which
you are enabling IPv6 OSPF.
Step 7
ipv6 rip
name
default-information
{
only |
originate
}
(Optional) Originate the IPv6 default route (::/0) in the RIP
routing process updates sent from the specified interface.
Note
To avoid routing loops after the IPv6 default route (::/0)
is originated from any interface, the routing process
ignores all default routes received on any interface.
•
only
—Select to originate the default route, but suppress all
other routes in the updates sent on this interface.
•
originate
—Select to originate the default route in addition
to all other routes in the updates sent on this interface.
Step 8
end
Return to privileged EXEC mode.
Step 9
show ipv6 rip
[
name
] [
interface
interface-id
]
[
database
] [
next-hops
]
or
show
ipv6 route rip
[
updated
]
Display information about IPv6 RIP processes.
Display the contents of the IPv6 routing table.
Step 10
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
