Cisco Catalyst 2960 Series, Configuration Manual

Page: 357 / 2288

DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if
prompted. enable
Example:
Switch> enable
Step 1
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the number of hops in a region before the BPDU is
discarded, and the information held for a port is aged. spanning-tree mst max-hops hop-count
Example:
Switch(config)# spanning-tree mst max-hops
25
Step 3
For hop-count , the range is 1 to 255; the default is 20.
Returns to privileged EXEC mode. end
Example:
Switch(config)# end
Step 4
Related Topics
Specifying the MST Region Configuration and Enabling MSTP , on page 261
Specifying the Link Type to Ensure Rapid Transitions
If you connect a port to another port through a point-to-point link and the local port becomes a designated
port, the RSTP negotiates a rapid transition with the other port by using the proposal-agreement handshake
to ensure a loop-free topology.
By default, the link type is controlled from the duplex mode of the interface: a full-duplex port is considered
to have a point-to-point connection; a half-duplex port is considered to have a shared connection. If you have
a half-duplex link physically connected point-to-point to a single port on a remote switch running MSTP, you
can override the default setting of the link type and enable rapid transitions to the forwarding state.
This procedure is optional.
Before You Begin
A multiple spanning tree (MST) must be specified and enabled on the switch. For instructions, see Related
Topics.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
275
How to Configure MSTP Features