Cisco Catalyst 2960 Series, Configuration Manual

Page: 320 / 2288

DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode. Enter your password if
prompted. enable
Example:
Switch> enable
Step 1
Enters the global configuration mode. configure terminal
Example:
Switch# configure terminal
Step 2
Configures the number of BPDUs that can be sent before
pausing for 1 second. spanning-tree transmit hold-count value
Example:
Switch(config)# spanning-tree transmit
hold-count 6
Step 3
For value , the range is 1 to 20; the default is 6.
Returns to privileged EXEC mode. end
Example:
Switch(config)# end
Step 4
Monitoring Spanning-Tree Status
Table 28: Commands for Displaying Spanning-Tree Status
Displays spanning-tree information on active interfaces only.
show spanning-tree active
Displays a detailed summary of interface information. show spanning-tree detail
Displays spanning-tree information for the specified VLAN.
show spanning-tree vlan vlan-id
Displays spanning-tree information for the specified interface. show spanning-tree interface
interface-id
Displays spanning-tree portfast information for the specified
interface. show spanning-tree interface
interface-id portfast
Displays a summary of interface states or displays the total lines
of the STP state section.
show spanning-tree summary
[
totals
]
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
238
Monitoring Spanning-Tree Status