Cisco Catalyst 2960 Series, Configuration Manual

Page: 2093 / 2288

appl_reqinfo
Retrieves previously saved information from the Embedded Event Manager (EEM). This Tcl command
extension provides support for retrieving information from EEM that has been previously saved with a unique
key, which must be specified in order to retrieve the information. Note that retrieving the information deletes
it from EEM. It must be resaved if it is to be retrieved again.
Syntax
appl_reqinfo key ?
Arguments
(Mandatory) The string key of the data. key
Result String
data %s
Where data is the application string data to be retrieved.
Set _cerrno
Yes
(_cerr_sub_err = 2) FH_ESYSERR (generic/unknown error from OS/system)
This error means that the operating system reported an error. The POSIX errno value that is reported with the
error should be used to determine the cause of the operating system error.
(_cerr_sub_err = 7) FH_ENOSUCHKEY (could not find key)
This error means that the application event detector info key or other ID was not found.
appl_setinfo
Saves information in the Embedded Event Manager (EEM). This Tcl command extension provides support
for saving information in the Embedded Event Manager that can be retrieved later by the same policy or by
another policy. A unique key must be specified. This key allows the information to be retrieved later.
Syntax
appl_setinfo key ? data ?
Arguments
(Mandatory) The string key of the data. key
(Mandatory) The application string data to save. data
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
2011
appl_reqinfo