Cisco Catalyst 2960 Series, Configuration Manual

Page: 1794 / 2288

action 2.0 cli command "enable"
action 3.0 cli command "config terminal"
action 4.0 cli command " ip route 192.0.2.0 255.255.255.224 192.0.2.12"
action 91.0 cli command "exit"
action 99.0 cli command "show ip route | incl 192.0.2.5"
Configuring EEM Class-Based Scheduling
To schedule Embedded Event Manager (EEM) policies and set policy scheduling options, perform this task.
In this task, two EEM execution threads are created to run applets assigned to the default class.
The EEM policies will be assigned a class using the class keyword when they are registered. EEM policies
registered without a class will be assigned to the default class. Threads that have default class, will service
the default class when the thread is available for work. Threads that are assigned specific class letters will
service any policy with a matching class letter when the thread is available for work.
If there is no EEM execution thread available to run the policy in the specified class and a scheduler rule for
the class is configured, the policy will wait until a thread of that class is available for execution. Synchronous
policies that are triggered from the same input event should be scheduled in the same execution thread.
SUMMARY STEPS
1.
enable
2. configure terminal
3.
event manager scheduler { applet | axp | call-home } thread class class-options number thread-number
4.
exit
DETAILED STEPS
Purpose Command or Action
Enables privileged EXEC mode.
enable
Step 1
Example:
Device> enable
• Enter your password if prompted.
Enters global configuration mode. configure terminal
Example:
Device# configure terminal
Step 2
Schedules EEM policies and sets policy scheduling options. event manager scheduler { applet | axp | call-home }
thread class class-options number thread-number
Step 3
• In this example, two EEM execution threads are
created to run applets assigned to the default class.
Example:
Device(config)# event manager scheduler applet
thread class default number 2
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1712
How to Write EEM Policies Using the Cisco IOS CLI