Cisco Catalyst 2960 Series, Configuration Manual

Page: 1757 / 2288

15E
XE 3E 15.0(1)M 12.4(22)T 12.4(20)T 12.2(33)SXH 12.2(18)SXF4
Cisco IOS
Software
Modularity 12.4(2)T
12.2(31)SB3
12.2(33)SRB 12.3(14)T
12.2(18)SXF5
12.2(28)SB
12.2(33)SRA 12.2(25)S Action
Yes Yes Yes Yes Yes Yes Yes Yes Yes Set or
modify a
named
counter
Yes Yes Yes Yes -- Yes -- -- Set the
state of a
tracked
object
Yes Yes Yes Yes Yes Yes Yes Yes Yes Switch to a
secondary
RP
Embedded Event Manager Actions
The CLI-based corrective actions that are taken when event detectors report events enable a powerful on-device
event management mechanism. Some EEM actions are available on every Cisco IOS release, but most EEM
actions have been introduced in a specific release. For details of which EEM action is supported in each Cisco
IOS release, see the EEM Actions Available by Cisco IOS Release concept in the
“ Writing Embedded Event
Manager Policies Using the Cisco IOS CLI
”
or the
“
Writing Embedded Event Manager Policies Using Tcl
”
modules. EEM supports the following actions:
• Executing a Cisco IOS command-line interface (CLI) command.
• Generating a CNS event for upstream processing by Cisco CNS devices.
• Setting or modifying a named counter.
• Switching to a secondary processor in a fully redundant hardware configuration.
• Requesting system information when an event occurs.
• Sending a short e-mail.
• Manually running an EEM policy.
• Publishing an application-specific event.
• Reloading the Cisco software.
• Generating an SNMP trap.
• Generating prioritized syslog messages.
• Reading the state of a tracked object.
• Setting the state of a tracked object.
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1675
Information About Embedded Event Manager