Cisco Catalyst 2960 Series, Configuration Manual

Page: 1295 / 2288

This is an example of an output message when the log-input keyword is entered:
00:04:21:%SEC-6-IPACCESSLOGDP:list inputlog permitted icmp 10.1.1.10 (Vlan1 0001.42ef.a400)
->
10.1.1.61 (0/0), 1 packet
A log message for the same sort of packet using the log keyword does not include the input interface
information:
00:05:47:%SEC-6-IPACCESSLOGDP:list inputlog permitted icmp 10.1.1.10 -> 10.1.1.61 (0/0), 1
packet
Examples: Troubleshooting ACLs
If this ACL manager message appears and [chars] is the access-list name,
ACLMGR-2-NOVMR: Cannot generate hardware representation of access list [chars]
The switch has insufficient resources to create a hardware representation of the ACL. The resources include
hardware memory and label space but not CPU memory. A lack of available logical operation units or
specialized hardware resources causes this problem. Logical operation units are needed for a TCP flag match
or a test other than
eq ( ne , gt , lt , or range ) on TCP, UDP, or SCTP port numbers.
Use one of these workarounds:
• Modify the ACL configuration to use fewer resources.
• Rename the ACL with a name or number that alphanumerically precedes the ACL names or numbers.
To determine the specialized hardware resources, enter the show platform layer4 acl map privileged EXEC
command. If the switch does not have available resources, the output shows that index 0 to index 15 are not
available.
For more information about configuring ACLs with insufficient resources, see CSCsq63926 in the Bug Toolkit.
For example, if you apply this ACL to an interface:
permit tcp source source-wildcard destination destination-wildcard range 5 60
permit tcp source source-wildcard destination destination-wildcard range 15 160
permit tcp source source-wildcard destination destination-wildcard range 115 1660
permit tcp source source-wildcard destination destination-wildcard
And if this message appears:
ACLMGR-2-NOVMR: Cannot generate hardware representation of access list [chars]
The flag-related operators are not available. To avoid this issue,
• Move the fourth ACE before the first ACE by using ip access-list resequence global configuration
command:
permit tcp source source-wildcard destination destination-wildcard
permit tcp source source-wildcard destination destination-wildcard range 5 60
permit tcp source source-wildcard destination destination-wildcard range 15 160
permit tcp source source-wildcard destination destination-wildcard range 115 1660
or
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
1213
Examples: Troubleshooting ACLs