Cisco Catalyst 2960 Series, Configuration Manual

Page: 1000 / 2288

Description Attribute Sub-Type Number Vendor-Specific
Company Code Number
Carries the authentication
information needed by the
home agent to authenticate
a mobile node during
registration. The
information is in the same
syntax as the
ip mobile
secure host <addr>
configuration command.
Basically it contains the
rest of the configuration
command that follows that
string, verbatim. It
provides the Security
Parameter Index (SPI),
key, authentication
algorithm, authentication
mode, and replay
protection timestamp
range.
spi 1 9 26
RADIUS Disconnect-Cause Attribute Values
Disconnect-cause attribute values specify the reason a connection was taken offline. The attribute values are
sent in Accounting request packets. These values are sent at the end of a session, even if the session fails to
be authenticated. If the session is not authenticated, the attribute can cause stop records to be generated without
first generating start records.
The table below lists the cause codes, values, and descriptions for the Disconnect-Cause (195) attribute.
The Disconnect-Cause is incremented by 1000 when it is used in RADIUS AVPairs; for example, disc-cause
4 becomes 1004.
Note
Table 92: Disconnect-Cause Attribute Values
Description Value Cause Code
No reason is given for the disconnect. No-Reason 0
The event was not disconnected. No-Disconnect 1
Reason unknown. Unknown 2
The call has been disconnected. Call-Disconnect 3
Consolidated Platform Configuration Guide, Cisco IOS Release 15.2(4)E (Catalyst 2960-X Switches)
918
Information about RADIUS