8-42
Catalyst 2928 Switch Software Configuration Guide
OL-23389-01
Chapter 8 Configuring Switch-Based Authentication
Configuring the Switch for Secure Socket Layer HTTP
Use the
no ip http server
global configuration command to disable the standard HTTP server. Use the
no ip http secure-server
global configuration command to disable the secure HTTP server. Use the
no
ip http secure-port
and the
no ip http secure-ciphersuite
global configuration commands to return to
the default settings. Use the
no
ip http secure-client-auth
global configuration command to remove the
requirement for client authentication.
To verify the secure HTTP connection by using a Web browser, enter https://
URL
, where the URL is the
IP address or hostname of the server switch. If you configure a port other than the default port, you must
also specify the port number after the URL. For example:
https://209.165.129:1026
or
https://host.domain.com:1026
Configuring the Secure HTTP Client
The standard HTTP client and secure HTTP client are always enabled. A certificate authority is required
for secure HTTP client certification. This procedure assumes that you have previously configured a CA
trustpoint on the switch. If a CA trustpoint is not configured and the remote HTTPS server requires client
authentication, connections to the secure HTTP client fail.
Beginning in privileged EXEC mode, follow these steps to configure a secure HTTP client:
Step 11
ip http timeout-policy idle
seconds
life
seconds
requests
value
(Optional) Specify how long a connection to the HTTP server can remain
open under the defined circumstances:
•
idle
—the maximum time period when no data is received or response
data cannot be sent. The range is 1 to 600 seconds. The default is
180 seconds (3 minutes).
•
life
—the maximum time period from the time that the connection is
established. The range is 1 to 86400 seconds (24 hours). The default
is 180 seconds.
•
requests
—the maximum number of requests processed on a
persistent connection. The maximum value is 86400. The default is 1.
Step 12
end
Return to privileged EXEC mode.
Step 13
show ip http server secure status
Display the status of the HTTP secure server to verify the configuration.
Step 14
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip http client secure-trustpoint
name
(Optional) Specify the CA trustpoint to be used if the remote HTTP server
requests client authentication. Using this command assumes that you have
already configured a CA trustpoint by using the previous procedure. The
command is optional if client authentication is not needed or if a primary
trustpoint has been configured.
