9
Step 2
Log in with the following credentials:
•
Username:
admin
•
Password:
ironport
Command-Line Interface
Step 1
Access the command-line interface locally or remotely:
•
To access the CLI locally, set up a terminal to connect to the serial
port using 9600 bits, 8 bits, no parity, 1 stop bit (
9600, 8, N, 1
) and
flow control set to Hardware. To physically connect the terminal,
see the
“Connect to the Appliance” section on page 7
).
•
To access the CLI remotely, initiate an SSH session to the IP address
192.168.42.42
.
Step 2
Log in as
admin
with the password
ironport
.
Step 3
At the prompt, run the
systemsetup
command.
Run the System Setup Wizard
The System Setup Wizard starts automatically when you access the appliance via
the web-based interface (or when you run the
systemsetup
command from the
command-line interface.)
Step 1
Start the System Setup Wizard.
Step 2
Accept the end user license agreement.
Step 3
Enter information from the
“Document Network Settings” section on
.
Step 4
Set anti-spam and anti-virus security settings.
Step 5
Review the configuration summary page.
Step 6
Click
Install this Configuration
.
