15-41
Cisco BTS 10200 Softswitch Troubleshooting Guide, Release 5.0.x
OL-8723-19
Chapter 15 Diagnostic Tests
Network Loopback Test for Network-based Call Signaling/Media Gateway Control Protocol Endpoints
TABLE: DESTINATION
DEST_ID=dest_sub_itu;CALL_TYPE=LOCAL;ROUTE_TYPE=SUB;ZERO_PLUS=N;INTRA_STATE=Y;DESCRIPTION=
ITU Sub dest: Allow LNP
query;GAP_ROUTING=N;ANI_DIGMAN_ID=dm_dest_sub_ani;DNIS_DIGMAN_ID=dm_dest_rn;CLDPTY_CTRL_RE
L_ALWD=N;CALL_SUBTYPE=NONE;ACQ_LNP_QUERY=PERFORM_LNP_QUERY;
TABLE: OFFICE_CODE
DIGIT_STRING=11501;OFFICE_CODE_INDEX=15;DID=N;CALL_AGENT_ID=CA146;DIALABLE=Y;NDC=1;EC=150;
DN_GROUP=1xxx;EC_DIGIT_STRING=1150;
TABLE: DN2SUBSCRIBER
OFFICE_CODE_INDEX=15;DN=1512;STATUS=ASSIGNED;RING_TYPE=1;LNP_TRIGGER=Y;NP_RESERVED=N;SUB_I
D=sipata2;LAST_CHANGED=2005-09-08 11:08:47.0;VIRTUAL_DN=N;PORTED_IN=N;
TABLE: SUBSCRIBER
ID=sipata2;CATEGORY=INDIVIDUAL;NAME=h15 sipata2
Larry;STATUS=ACTIVE;BILLING_DN=11501512;DN1=11501512;PRIVACY=NONE;RING_TYPE_DN1=1;PIC1=NON
E;PIC2=NONE;PIC3=NONE;GRP=N;USAGE_SENS=Y;SUB_PROFILE_ID=hungary_prof;TERM_TYPE=SIP;IMMEDIA
TE_RELEASE=N;TERMINATING_IMMEDIATE_REL=N;[email protected];SEND_BDN_AS_CPN=N;
SEND_BDN_FOR_EMG=N;PORTED_IN=N;BILLING_TYPE=NONE;VMWI=Y;SDT_MWI=Y;
Reply : Success:
btsadmin>
Network Loopback Test for Network-based Call
Signaling/Media Gateway Control Protocol Endpoints
This section describes the feature that provides the capability to perform network loopback test on any
line side PacketCable Network-based Call Signaling protocol specification/Media Gateway Control
Protocol (NCS/MGCP) Residential Gateways initiated from designated test endpoints. This document
also describes enhancements to the TDM bearer path test call feature.
This section contains the following:
•
•
•
•
•
