DETAILED STEPS
Purpose
Command or Action
Enables privileged EXEC mode.
enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.
configure terminal
Example:
Device# configure terminal
Step 2
Specifies the hold time.
lldp holdtime seconds
Example:
Device(config)# lldp holdtime 100
Step 3
Returns to privileged EXEC mode.
end
Example:
Device(config)# end
Step 4
Setting LLDP Packet Frequency
Perform this task to specify an interval at which the Cisco software sends LLDP updates to neighboring
devices.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
lldp timer rate
4.
end
DETAILED STEPS
Purpose
Command or Action
Enables privileged EXEC mode.
enable
Step 1
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
337
Using Link Layer Discovery Protocol in Multivendor Networks
Setting LLDP Packet Frequency
