Purpose
Command or Action
Statically defines a remote MEP with a specified ID,
VLAN, and domain.
mep crosscheck mpid id vlan vlan-id
[
mac mac-address
]
Example:
Device(config-ether-cfm)# mep crosscheck mpid 702
vlan 100
Step 4
Returns to global configuration mode.
exit
Example:
Device(config-ether-cfm)# exit
Step 5
Configures the maximum amount of time that the
device waits for remote MEPs to come up before the
cross-check operation is started.
ethernet cfm mep crosscheck start-delay delay
Example:
Device(config)# ethernet cfm mep crosscheck
start-delay 60
Step 6
Returns to privileged EXEC mode.
exit
Example:
Device(config)# exit
Step 7
Enables cross-checking between MEPs.
ethernet cfm mep crosscheck
{
enable
|
disable
}
level
{
level-id
|
level-id-level-id
[
,level-id-level-id
]}
vlan
{
vlan-id
|
any
|
vlan-id-vlan-id
[
,vlan-id-vlan-id
]}
Step 8
Example:
Device# ethernet cfm mep crosscheck enable level 7
vlan 100
Configuring and Enabling Cross-Checking for an Outward Facing MEP on the CE-B
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ethernet cfm domain domain-name level level-id
[
direction outward
]
4.
mep crosscheck mpid id vlan vlan-id
[
mac mac-address
]
5.
exit
6.
ethernet cfm mep crosscheck start-delay delay
7.
exit
8.
ethernet cfm mep crosscheck
{
enable
|
disable
}
level
{
level-id
|
level-id-level-id
[
,level-id-level-id
]}
vlan
{
vlan-id
|
any
|
vlan-id-vlan-id
[
,vlan-id-vlan-id
]}
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
195
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM
