31
Buffer logging: level debugging, 81 messages logged, xml disabled,
filtering disabled
Exception Logging: size (4096 bytes)
Count and timestamp logging messages: disabled
Persistent logging: disabled
No active filter modules.
Trap logging: level informational, 78 message lines logged
Log Buffer (10000000 bytes):
*Jan 10 06:08:14.713: %CMRP-3-PEM_REMOVE_SHUT: R0/0: cmand: The system will shut down in 5 minutes
*Jan 10 06:08:14.718: %ASR1000_PEM-6-REMPEM_FM: PEM/FM slot P1 removed
*Jan 10 06:08:28.966: %ASR1000_PEM-6-INSPEM_FM: PEM/FM slot P1 inserted
The second is after enabling console logging. Output is at the console (and in the log).
2ru_perf2#conf Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
2ru_perf2(config)#log con
% Ambiguous command: "log con"
2ru_perf2(config)#logg con
2ru_perf2(config)#^Z
2ru_perf2#
*Jan 10 06:08:54.643: %SYS-5-CONFIG_I: Configured from console by console
2ru_perf2#
2ru_perf2# *Jan 10 06:09:05.023: %CMRP-3-PEM_REMOVE_SHUT: R0/0: cmand: The system will shut down in 5
minutes
*Jan 10 06:09:05.026: %ASR1000_PEM-6-REMPEM_FM: PEM/FM slot P0 removed
*Jan 10 06:09:10.500: %ASR1000_PEM-6-INSPEM_FM: PEM/FM slot P0 inserted
2ru_perf2#
Step 5
Replace the AC power supply within five minutes or the system will shutdown
You have removed an AC power supply from the Cisco ASR 1002-F Router and now must replace the AC power supply within
five minutes.
Installing the AC Power Supply
Step 1
Insert an AC power supply in power supply Slot 0 or power supply Slot 1 until it is full seated.
Step 2
Tighten the captive installation screws.
Step 3
At the rear of the router, check that the power switch is in the Off (O) position.
Step 4
Insert the AC power cord into the power inlet and then turn it On (I).
Step 5
To ensure that the AC power cord does not interfere with other cables or wires, dress the AC power cable in one of the
following ways.
a.
Leave a small service loop in the AC power cord from the inlet and then secure the power cord through the AC power
supply handle as shown in
Figure 17
. Or go to 5b.