Removing and Replacing Cisco ASR 1000 Series Route
Processors
Keep in mind the following points before you remove and replace a Cisco ASR 1000 Series route processor:
•
The Cisco ASR 1002 Router and the Cisco ASR 1002-F Router support only the integrated Cisco
ASR1002-RP1.
•
If you have two Cisco ASR 1000 Series route processors in the Cisco ASR 1006 or Cisco ASR 1013
router and you want to remove one, do not power down the router. Remove the route processor and
insert a new one because high availability provides for the other route processor to take on the processing
tasks for the router.
•
The Cisco ASR 1001 Router and the Cisco ASR 1002-X Router support an integrated route processor,
embedded services processor, and SIP.
The following sections describe the procedures for removing and replacing the Cisco ASR 1000 Series RP1
and Cisco ASR1000-RP2 in your Cisco ASR 1000 chassis. This section contains these topics:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to any card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Warning
Removing the Cisco ASR 1000 Series Route Processor from the Cisco ASR
1006, Cisco ASR 1004, and Cisco ASR 1013 Routers
To remove the Cisco ASR 1000 Series route processor (RP1 or RP2) from the Cisco ASR 1006 Router, Cisco
ASR 1004 Router and Cisco ASR 1013 Router, follow this procedure:
SUMMARY STEPS
1.
Slip on an ESD-preventive wrist strap and attach it to a chassis surface.
2.
If connected, remove any I/O cables from the Cisco ASR 1000 Series route processor.
3.
Using a number 2 Phillips or a 3/16-inch flat-blade screwdriver, loosen the two captive screws on the
faceplate of the Cisco ASR 1000 Series route processor.
4.
Using the handles on both sides of the module, with two hands gently slide the module out of the chassis
slot.
5.
Place the Cisco ASR 1000 Series route processor module on an antistatic surface with its printed circuit
board components facing upward or in a static shielding bag.
Cisco ASR 1000 Series Router Hardware Installation Guide
474
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Removing and Replacing Cisco ASR 1000 Series Route Processors
Summary of Contents for ASR 1001
Page 2: ... 2013 2017 Cisco Systems Inc All rights reserved ...
Page 20: ...Cisco ASR 1000 Series Router Hardware Installation Guide xx Contents ...
Page 30: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxx Preface Warning Definition ...
Page 32: ...Cisco ASR 1000 Series Router Hardware Installation Guide xxxii Preface Warning Definition ...
