Cisco ASR 1001, Hardware Installation Manual

Page: 339 / 702

Connecting the Shared Port Adapter Cables
The instructions for connecting the cables for the shared port adapter (SPA) installed in the Cisco ASR 1002-F
Router are contained in the respective configuration documents for SPAs. For detailed SPA information, see
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide .
Connecting the Console and Auxiliary Port Cables
This section describes how to attach a cable to the Cisco integrated RP console or auxiliary ports on the Cisco
ASR 1002-F Router. The Cisco ASR 1002-F Router uses RJ-45 ports for both the auxiliary port and console
port to attach a console terminal.
To meet Class A emission requirements on the Cisco ASR 1002-F Router, shielded cables must be used
for the console and auxiliary port connectors.
Caution
Before you can use the console interface on the router using a terminal or PC, you must perform the following
steps:
Step 1 Before connecting a terminal to the console port or auxiliary port, configure the terminal to match the chassis console
port as follows: 9600 baud, 8 data bits, no parity, 1 stop bits (9600 8N1).
Step 2 Connect to the port using an RJ-45 cable to a DB-9 cable.
For information about how to change the default settings to meet the requirements of your terminal or host, see
Cisco IOS Terminal Services Configuration Guide . For route processor pinout specifications, see the
“
Cisco
ASR1000-RP2 Pinout Specifications ” section.
Note
The following figure shows the integrated RP console and auxiliary port connectors.
Figure 135: Cisco ASR 1002-F Router Integrated RP Console and Auxiliary Port Connectors
Auxiliary port (AUX) 2 Console port (CON) 1
Cisco ASR 1000 Series Router Hardware Installation Guide
305
Cisco ASR 1002-F Router Overview and Installation
Connecting the Shared Port Adapter Cables